TECHNICAL DATA SRT-13
STOPS RUST
COLD GALVANIZING SPRAY
Form: CS2211
Rev.: 030513
.DESCRIPTION AND USES .
Rust-Oleum
®
Stops Rust
®
Cold Galvanizing Spray
provides maximum corrosion resistance through galvanic
protection. Use for touch-up and repair to damaged
galvanized steel, galvanized ducts, fences, gutters, trucks,
trailers, and more. Do not topcoat with an alkyd finish.
.PRODUCTS .
SKU (16 ounce spray) Description
7785830 Galvanizing Compound
..PRODUCT APPLICATION .
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Apply when temperature is between 50-90°F (10-
32°C) and humidity is below 65% to ensure proper drying.
Do not apply to surfaces, when heated, exceed 200°F
(93°C). Avoid spraying in very windy and dusty conditions.
Cover surrounding area to protect from spray mist.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical
contaminants by washing the surface with a commercial
detergent, or other suitable cleaning method. Rinse with
fresh water and allow to thoroughly dry. Remove loose
paint and rust with a wire brush or sandpaper. WARNING!
If you scrape, sand or remove old paint from any surface,
you may release lead paint dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN
CHILDREN. PREGNANT WOMEN SHOULD ALSO
AVOID EXPOSURE. Wear a NIOSH approved respirator
to control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National
Lead Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
PRODUCT APPLICATION .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can upright 10-16" from surface and spray in a
steady back-and-forth motion, slightly overlapping each
stroke. Keep the can the same distance from the surface.
Keep the can in motion while spraying. Apply two or more
light coats a few minutes apart to avoid drips and runs. Do
not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F and 50% relative
humidity. Allow more time at cooler temperatures. Dries to
touch in 15 minutes, to handle in 1-2 hours and fully dry in
24 hours. If a topcoat is desired, use a latex coating.
CLEAN-UP
Clean valve immediately after use by turning can upside
down and depressing spray button for 3-5 seconds. Clean
up wet paint with xylene or mineral spirits. Properly
discard empty container. Do not burn or place in home
trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.
(3 pages)
(1 pages)
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels